Thread: DIY Cat Product
View Single Post
  #4  
Old 08-14-2008, 03:15 PM
imann's Avatar
imann imann is offline
Purrfect lover
 
Join Date: Aug 2008
Location: Nilai
Posts: 1,487
Rep Power: 17
imann is on a distinguished road
Send a message via Yahoo to imann
Default Re: DIY Cat Product





Cat Tree How-To
1. Use a tree saw to cut the trunk of a sturdy piece of branched wood so that it forms a flat surface.

2. On a 1 1/2-inch-thick piece of wood that is wide enough to provide a stable base (this one is about 15 inches across), draw intersecting lines. On the base, mark trunk's footprint at approximate center. Mark placement of four 3-inch wood screws, as shown.

3. Drill pieces together.

4. Remove bark from the base if desired.
__________________
Reply With Quote